Bottle Washer Pro Long Centre Tube: Replacement Guide
By Baby Brezza UK | Published: 2026-10-16
Category: How-to Guides
Learn how to tell when your Bottle Washer Pro long centre tube needs replacing and follow a simple step-by-step process to fit the genuine Baby Brezza UK spare part.
Quick answer
If your Bottle Washer Pro is not spraying properly, the long centre tube is often the culprit. Order the genuine Baby Brezza UK Replacement Long Centre Tube (product 2410410), unplug the washer, remove the old tube, push the new one firmly into place, and run a rinse cycle to confirm water flows from all jets.
Signs the long centre tube needs replacing
The long centre tube is the vertical channel that feeds water to the spray jets inside the Bottle Washer Pro. When it cracks, clogs, or loosens, you may notice weak spray, dry patches on bottles after a full cycle, or an error message about water flow. Unlike a general cleaning issue, a damaged tube will not improve with detergent tablets or a descaling cycle. If you have already cleaned the spray arm and checked the detergent dosage, the centre tube is the next logical part to inspect.
Before you start: tools and safety
You do not need special tools for this replacement. Work near a sink with a towel handy. Always unplug the Bottle Washer Pro from the mains before removing any internal part. The tube itself is a single component, so there are no small screws or clips to lose. If your washer is still under warranty, check the terms first; fitting a genuine Baby Brezza UK part normally keeps you covered, but keep your receipt.
How to replace the long centre tube step by step
- Unplug and empty the washer: Switch off at the wall, pull the plug, and remove the detergent tablet if one is loaded. Lift out the basket and any bottles or pump parts. Tip the unit forward slightly to drain standing water from the base into a sink. Checkpoint: the washer should be completely dry and cool before you touch the tube.
- Remove the old long centre tube: Grip the tube near its base and pull it straight up. Do not twist or lever it with a tool, as this can crack the plastic housing around the socket. If the tube feels stuck, wiggle it gently while pulling upward. Common mistake: forcing a stuck tube can damage the internal water connector, turning a simple part swap into a repair.
- Inspect the socket and surrounding area: Look into the empty socket for limescale, trapped food residue, or bits of broken plastic. Wipe the opening with a damp cloth. If you see heavy scale, run a descaling cycle before fitting the new tube. Checkpoint: a clean socket helps the new tube seat fully and prevents immediate spray problems.
- Fit the new genuine long centre tube: Align the flat side of the new tube with the matching slot in the socket. Push down firmly until the tube sits flush with the washer base. You should feel it stop rather than wobble. Common mistake: not pushing the tube all the way down leaves a gap that causes water to bypass the jets.
- Run a rinse cycle and check spray: Reassemble the basket, fill the water tank, and run a short rinse cycle without bottles or detergent. Watch for even water flow from the spray jets and check for leaks around the base of the tube. If spray is still weak, remove the tube and reseat it; if the problem continues, contact Baby Brezza UK support.
The part you need
- Bottle Washer Replacement Long Centre Tube: Genuine Baby Brezza UK replacement long centre tube, compatible with the Bottle Washer Pro. A precise fit means the tube seals correctly and delivers water to every spray jet, so you avoid repeat leaks or weak cleaning.
If you keep a spare long centre tube in the cupboard, you can fix a spray problem the same day instead of waiting for a delivery. Order the genuine part from Baby Brezza UK and follow the five steps above whenever spray performance drops.
