Replace Bottle Washer Pro Short Centre Tube in 5 Steps

Quick answer

You can replace the short centre tube on your Baby Brezza Bottle Washer Pro in about five minutes with no tools. Follow the steps below and avoid the common mistake of misaligning the tube when sliding it into place.

Step-by-step replacement guide

1. 1. Unplug the Bottle Washer Pro: Disconnect the machine from the power outlet. This is a safety precaution before you begin any disassembly. Never skip unplugging — even if the machine appears off, internal components may still hold a charge.
2. 2. Remove the upper rack and spray arm: Pull out the upper rack completely. Then, unscrew or unclip the top spray arm (depending on your model) and set both aside. Common mistake: Forgetting to remove the spray arm first can crack it when you try to lift the centre tube.
3. 3. Locate and lift out the old short centre tube: The short centre tube sits in the centre of the lower basket, connecting to the water inlet. Grip it firmly and pull upward to release it from its base. If the tube feels stuck, rock it gently side to side — do not yank, or you may damage the base fitting.
4. 4. Insert the new short centre tube: Align the bottom of the new tube with the water inlet opening and push down firmly until it clicks into place. Ensure it sits straight and flush. Common mistake: Inserting the tube at an angle. This prevents a proper seal and can cause leaks during the wash cycle.
5. 5. Reattach the spray arm and upper rack: Clip or screw the top spray arm back onto the new tube, then slide the upper rack back into position. After reassembly, run a rinse cycle to check for leaks before loading bottles.

What you need

• Bottle Washer Replacement Short Centre Tube: The Bottle Washer Replacement Short Centre Tube is manufactured to original Baby Brezza specifications and compatible with the Bottle Washer Pro model. Using an official replacement ensures a precise fit, so you don't have to worry about leaks or poor water flow after installation.